| To: | tentec@contesting.com |
|---|---|
| Subject: | Re: [TenTec] non qsk amp |
| From: | "Dr. Gerald N. Johnson" <geraldj@weather.net> |
| Reply-to: | geraldj@weather.net, Discussion of Ten-Tec Equipment <tentec@contesting.com> |
| Date: | Fri, 24 Dec 2010 21:06:59 -0600 |
| List-post: | <mailto:tentec@contesting.com> |
On the Corsair II control board, it looks like increase C6 or R12
preferably R35 better than R12. C6 is 33 mfd, R35 is a 10K pot. Don't
have anything on hand for the 544, but its probably similar.
73, Jerry, K0CQ On 12/24/2010 8:19 PM, k8bbm@srt.com wrote: hi, using 544, corsair II - want to key an old amp - NCL2000 - but the delay adjustment for CW in the rigs has narrow range - I would like to slow the relay down a bit more..... suggestions to change circuitry for delay of relay?? thanks dave nd0cw nd0cw@srt.com |
| <Prev in Thread] | Current Thread | [Next in Thread> |
|---|---|---|
| ||
| Previous by Date: | Re: [TenTec] non qsk amp, Dr. Gerald N. Johnson |
|---|---|
| Next by Date: | Re: [TenTec] non qsk amp, Phil Chambley Sr. |
| Previous by Thread: | Re: [TenTec] non qsk amp, Dr. Gerald N. Johnson |
| Next by Thread: | Re: [TenTec] non qsk amp, Phil Chambley Sr. |
| Indexes: | [Date] [Thread] [Top] [All Lists] |