Monday 0500 EST
I had the same problem, Jim:
Only I was using the Kam-PLUS and doing g-tor in the MARS program.
I was able to receive, but not transmit.......with the Jupiter.
I solved my problem by going back to my FT_900-AT and the Kam-PLUS.
Now the MARS don't use g-tor, instead they use FT-63 and audio system
And the Jupiter works fine.
73
alsirois@roadrunner.com
N1MHC@arrl.net
Nnn0wna
=======================
-----Original Message-----
From: tentec-bounces@contesting.com [mailto:tentec-bounces@contesting.com]
On Behalf Of James C. Owen, III
Sent: Sunday, December 19, 2010 6:04 PM
To: Ten-Tec
Subject: [TenTec] Argonaut V-Jupiter-Signalink USB and Digital
Not wanting to re-engineer something that likely already has been done.
Here's
my problem! Recently got on the digital modes with a signalinkUSB that
works
fine with the Argonaut V, all gain controls pretty much centered. Connected
to
the Jupiter and had nothing but overdrive even with all gain controls at
minimum. I then looked at the spec's of the two. Argonaut V 100mv into 47
ohms,
Jupiter 1mv into 47 ohms. So the Jupiter is 100 times more sensitive, so
that's
the problem. I'm thing of a simple T attenuator which will require me to
make
another cable. Has anyone come up with a good simple solution?
73 Jim K4CGY
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|