Howard:
L1 is used to adjust the frequency of the 9.00 MHz crystal. T1 is a 455
kHz tuned circuit. You can probably make a new one from an old 455 kHz
IF transformer. Q1 and Q2 are type MPS-3693. I'm sure that you can find
them or an acceptable substitute. Unfortunately, the values or part
numbers of L1 and T1 are not given. I'm sure that Ten-Tec can help you
with this.
I have the data sheet for the FM board. I can scan it for you. It shows
how to interconnect the board and provides a circuit description and
schematic.
73,
Bob WB2VUF
On 12/5/2010 8:14 AM, Howard Payne wrote:
> Hi
> Well it seems that this Paragon 585 has had a hard life!!
> Coil L1 is mashed up!!.
> 455Khz Quad coil (T1) is also mashed up!!.
> Both crystals are missing, Y1(9.000Mhz) Y2 (8.545Mhz).
> Both Q1/Q2 are missing.
> Also there are no wires there to connect the board to the rest
> of the radio!
> Other than that the radio works fine.
>
> Could do with a good copy of the circuit of the 256 fm adapter
> board.
>
> Anyone have any of these parts , or where to get them from ??
> --
> 73's Howard G7LQY
> GQRP: 12549
> Loc: IO83UO
> LARGE FILES TO: hjpayneg7@yahoo.com
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
>
>
> -----
> No virus found in this message.
> Checked by AVG - www.avg.com
> Version: 10.0.1170 / Virus Database: 426/3297 - Release Date: 12/04/10
>
>
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|