| To: | <tentec@contesting.com> |
|---|---|
| Subject: | [TenTec] Paragon board adjustments |
| From: | "Jeff" <kd4lyh@bellsouth.net> |
| Reply-to: | Discussion of Ten-Tec Equipment <tentec@contesting.com> |
| Date: | Thu, 22 Apr 2010 15:44:23 -0400 |
| List-post: | <tentec@contesting.com">mailto:tentec@contesting.com> |
I have replaced a shorted diode in the swr bridge circuit on the LPF board. What steps to adjust ALC limit r47 and ic limit r57 do I use. Do I connect an external ammeter and adjust ic for 22amps? And what should I be looking for when adjusting the ALC limit pot r47? Best Regards Jeff kd4lyh No virus found in this outgoing message. Checked by AVG - www.avg.com Version: 9.0.814 / Virus Database: 271.1.1/2828 - Release Date: 04/22/10 02:31:00 _______________________________________________ TenTec mailing list TenTec@contesting.com http://lists.contesting.com/mailman/listinfo/tentec |
| <Prev in Thread] | Current Thread | [Next in Thread> |
|---|---|---|
| ||
| Previous by Date: | [TenTec] Extend RIT on Argosy or Scout?, Bill Acito W1PA |
|---|---|
| Next by Date: | Re: [TenTec] Extend RIT on Argosy or Scout?, Stuart Rohre |
| Previous by Thread: | [TenTec] Extend RIT on Argosy or Scout?, Bill Acito W1PA |
| Next by Thread: | Re: [TenTec] Paragon board adjustments, Stuart Rohre |
| Indexes: | [Date] [Thread] [Top] [All Lists] |