Hello Steve: Check my website for information on setting your O2 power output.
There is a picture on the site showing the board for adjustments. The PWR
control is used to calibrate the on board average power meter. Make your
calibration at full scale. 73 and Happy DXing, Mike W2AJI
http://home.earthlink.net/%7Echerokeehillfarm/id2.html
-----Original Message-----
From: Steve Narducci
Sent: 2/8/2010 9:06:54 PM
To: 'Discussion of Ten-Tec Equipment'
Subject: [TenTec] Orion 2 output power
I picked up a second hand Orion 2 six months ago.
The output power is off on its reading as I am sure the previous owner
played with this.
While reading 65 watts it really puts out 100W.
It will go way above 100W if I run her up.
However, I really want to bring it back into specs.
Anyone have a how-to guide on doing that?
Thanks in advanced!
Steve W9SN
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|