Wednesday 3 Feb 2010
0500 EST
GM, Roger:
I upgraded my T-T's and upgraded to #538 Jupiter's ( I have 2 of them now. )
And 2 Scouts #555.-
73
N1mhc@arrl.net
Al Sirois
East Boothbay, ME 04544-0002
============================
-----Original Message-----
From: Roger Rippy [mailto:svtincup@yahoo.com]
Sent: Tuesday, February 02, 2010 7:50 AM
To: TenTec@contesting.com
Subject: [TenTec] Old vs New = crunch time
The thread last month regarding the Omni VI+ the best rig etc, certainly got
me thinking about the next Ten Tec rig. Please keep in mind that I really
like the "keep it simple" approach to most things and Ham radio has not been
an exception. It is time to seriously consider the next radio for my shack
and the decision crunch is between a previously owned rig and a new one. My
current set up is a Ten Tec Triton barefoot into a Force 12 XK40 (also have
a K-1 for QRP and an Alinco DX70 for mobile). When I think about the price
of a new radio, I start thinking the ole Triton sure is a good radio for my
Ham activity (95% cw). But I know it is time to consider an additional Ten
Tec for the future. I spoke with Ten Tec service yesterday and they were
helpful discussing the pros and cons of maintaining an older rig in terms of
parts. I also have been reading the comments on this list for some time
regarding the maintenance issues involving software driven
radios.
So the question is "If you wanted a relative simple radio for CW work (use
is 75% rag chew; 15% contest; and 10% DX)and you had to keep the cost down,
would you opt for an older rig such as a Corsair II or a software driven
older rig such as an Omni VI or spring for something in the price range of a
new Jupiter? My budget is somewhere between $600 and $1800 which rules out a
number of options.
I realize that this is not the first time this has been discussed but
after reading over a year's worth of archives, I still did not find my
answer. Ten Tec stated that if I was good at troubleshooting and
maintaining my own gear then an older radio would be fine as long as
I could find the parts that I need. Building a K-1 kit, hardly qualifies
me to do much in the troubleshooting department!
Any constructive thoughts would certainly be welcome either off-line or on
the list. Thanks and 73s
Roger Rippy W7RIP
Bozeman, Montana
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|