It all started with my screen adding and dropping pixels which had the
effect of adding mostly extra lines and/or deleting parts of lines. The
general advice was to re-seat the connecting cable a few times. TT
added that it might be that my screen was on the way out.
Sounded as though it was worth a try so I opened up the box and reseated
the cable a few times. Seemed to work so I was feeling good. I should
have known better! A few days ago I went to change the step and it
would not move. It is/was stuck at 100 hz. I can make it move to 1 hz.
with an alt/step. A full reset returns it to 100 hz. All of the other
functions work normally, ie. Audio level, RF level so I don't believe
it's the encoder.
Has anyone else bumped into this and found a cure. There is a second
cable next to to the display cable. Can that be the culprit? Any
suggestions short of trading in the Jupiter for a K3 et al are welcome.
--
John Graves
WA1JG
jh.graves@verizon.net
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|