| To: | tentec@contesting.com |
|---|---|
| Subject: | Re: [TenTec] Bias Adjustment on Century 21 |
| From: | w8au@sssnet.com |
| Reply-to: | Discussion of Ten-Tec Equipment <tentec@contesting.com> |
| Date: | Tue, 16 Jun 2009 13:36:06 -0400 |
| List-post: | <tentec@contesting.com">mailto:tentec@contesting.com> |
At 12:45 PM 6/16/2009, geoffrey mendelson wrote: > > My question is basically where/how (in physical terms) do you measure > > this current? The final amp is a sealed unit for all practical > > purposes. The 12V buss enters the PA section through a feed-thru insulator. Usually a RED insulated wire. Just unsolder this lead and insert the VOM. Perry w8au _______________________________________________ TenTec mailing list TenTec@contesting.com http://lists.contesting.com/mailman/listinfo/tentec |
| <Prev in Thread] | Current Thread | [Next in Thread> |
|---|---|---|
| ||
| Previous by Date: | Re: [TenTec] Bias Adjustment on Century 21, Tom at Hayseed Hamfest Co. |
|---|---|
| Next by Date: | Re: [TenTec] Bias Adjustment on Century 21, w8au |
| Previous by Thread: | Re: [TenTec] Bias Adjustment on Century 21, Richards |
| Next by Thread: | Re: [TenTec] Bias Adjustment on Century 21, w8au |
| Indexes: | [Date] [Thread] [Top] [All Lists] |