What happens if you just turn the radio off and then back on? Does that get
it working again?
Carl Moreschi N4PY
121 Little Bell Dr
Bell Mountain.
Hays, NC 28635
----- Original Message -----
From: "Bob Close" <rclose@nhwisp.com>
To: "Discussion of Ten-Tec Equipment" <tentec@contesting.com>
Sent: Friday, May 15, 2009 5:23 AM
Subject: Re: [TenTec] Orion 565 Problem with 2.063Xg??
seems the radio works, but not with someone else's software, so that means
it's a problem with
Ten-Tec's software????
Call N4PY seems more appropriate
--------------------------------------------------
From: "Rick W" <ve7tk@yahoo.ca>
Sent: Friday, May 15, 2009 1:27 AM
To: "Ten-Tec Reflector" <tentec@contesting.com>
Subject: [TenTec] Orion 565 Problem with 2.063Xg??
I think I've found a problem with 2.063Xg. Here's the scenario.
1) I have my 565 under the control of the N4PY software.
2) I go to the RX menu and toggle the AGC System Type (it doesn't seem
to matter which way I go).
3) Back out of the menus
After doing this exercise I lose all serial control of the Orion. In
addition the remote pod doesn't work. The work-around is to turn off the
software and reboot the Orion.
IF I am not using the serial port with an external program and toggle the
AGC the remote pod works BUT when I try to start some external software
the serial port is dead. The same work-around solves the problem.
Before I report this to T-T I'd be curious if others are experiencing
this?
Thanks.
73,
Rick
VE7TK
Website: http://www3.telus.net/ve7tk
__________________________________________________________________
The new Internet Explorer® 8 - Faster, safer, easier. Optimized for
Yahoo! Get it Now for Free! at
http://downloads.yahoo.com/ca/internetexplorer/
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|