TenTec
[Top] [All Lists]

Re: [TenTec] Orion - OT

To: "Discussion of Ten-Tec Equipment" <tentec@contesting.com>
Subject: Re: [TenTec] Orion - OT
From: "Bob McGraw - K4TAX" <RMcGraw@Blomand.net>
Reply-to: Discussion of Ten-Tec Equipment <tentec@contesting.com>
Date: Fri, 27 Mar 2009 20:39:11 -0500
List-post: <mailto:tentec@contesting.com>
The easy and 100% solution is to turn off Windows sounds in the control panel. After all, we've heard those things in the shack and office for years and long enough and who cares about some stupid ding dong that contains absolutely no intelligent information.

I'll also add my comment regarding using the headphones signal for the RX audio to the computer as it is after the volume control and thus affected by same. Better to use the line output on the radio which is before the volume control thus allowing one to turn off or to turn down the volume if they so choose and thus not affect the signal to the sound card.

As to feeding the audio into the mic input, again, not a good idea specially if there is a line input available for the TX signal. One is much less likely to get hum and ground loops and RF in the audio as the higher level provides a much better S/N ratio. My general rule is; "if it is not a mike, then don't connect it to the mike input". Works every time.

The exception to using or not using some type of interface is ones preference to use PSK. That does require an interface and related connection to the radio. The use of AFSK is generally more accurate and easier to interface and operate.

73
Bob, K4TAX




----- Original Message ----- From: "jerome schatten" <romers@shaw.ca>
To: "Discussion of Ten-Tec Equipment" <tentec@contesting.com>
Sent: Friday, March 27, 2009 11:20 AM
Subject: Re: [TenTec] Orion - OT


Yep... I can see your point Gary, but abandoning the principle of
parsimony in the face of improbable events of little consequence seems
unnecessarily restrictive.

Myriads of VOX stories with unintended consequences abound. But in the
grand scheme of things, the smoke goes up the chimney just the same.

KISS by using VOX as Ed indicates, decreases the entropy caused by the
added complexity of the interface -- this is overall, a good thing.

Best,
jerome - VA7VV



On Fri, 27 Mar 2009 09:12:46 -0700, CSM(r) Gary Huber
<glhuber@msn.com> wrote:

RE: Using VOX.....

If you happen to "view" a multi media file with sound, the sound can
transmitted over the air as it trips the VOX. Using a serial port
(or USB to serial) to initiate PTT provides control to avoid
accidental VOX transmission. I've made the VOX mistake and I often
hear others sending audio instead of PSK-31 data.

Best regards,

CSM(r) Gary Huber - AB9M
9679 Heron Bay Rd
Bloomington, IL 61705
(309-662-0604)
www.csm-gh.com
glhuber@msn.com
gary.huber@us.army.mil

--------------------------------------------------
From: "jerome schatten" <romers@shaw.ca>
Sent: Friday, March 27, 2009 9:31 AM
To: "Discussion of Ten-Tec Equipment" <tentec@contesting.com>
Subject: Re: [TenTec] Orion - OT

Right on! I've used VOX to key the rig with MixW and Fldigi across
many rigs: FT920, IC706, IC7K, Pro3, and a TT Jupiter. Works slick
and
easy. Two cables: one from the soundcard to the mic input of the
rig;
the other from the rig audio (headphone jack works) to the sound
card.
That's it. Save your money!

jerome - VA7VV


On Fri, 27 Mar 2009 05:48:09 -0700, Bob McGraw - K4TAX
<RMcGraw@Blomand.net> wrote:

I don't use any type of interface with MixW.  Just feed the audio
to
and
from the radio and computer and let the VOX handle the keying.

Less parts, less cables = less problems.

73
Bob, K4TAX


----- Original Message -----
From: "jack User" <jfriend31@comcast.net>
To: "Discussion of Ten-Tec Equipment" <tentec@contesting.com>
Sent: Thursday, March 26, 2009 4:43 PM
Subject: Re: [TenTec] Orion - OT


Lloyd, what kind of switching are you using for keying your O? i
use
MixW and have it send the keying to a COM port. the switch i use
is
one
shown in the MixW help file. you can set most any COM port or USB
to COM
port you choose in MixW.
jack ak7o



On Thu, 2009-03-26 at 16:48 -0400, Lloyd Westbrook wrote:
Having trouble keying my Orion with MixW. Been off PSK for 4 yrs
and have
a
new computer ( XP ), using a Rascal , all seems to be working OK
except
program doesn't key rig. Any help with settings would be
appreciated.

Thanks, Lloyd W4AO

_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec

_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec



_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec



--
Using Opera's revolutionary e-mail client:
http://www.opera.com/mail/
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec

_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec



--
Using Opera's revolutionary e-mail client: http://www.opera.com/mail/
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec




<Prev in Thread] Current Thread [Next in Thread>