Jim: That's exactly what I am seeing and what I believe has been
described
by others. The 'spectrum trace' red (which is a peak-hold trace) is all
you're supposed to see and is one of the improvements over the previous
versions.
Ron N6IE
www.N6IE.com
----- Original Message -----
From: "Jim M." <jmiller1706@cfl.rr.com>
To: "'Discussion of Ten-Tec Equipment'" <tentec@contesting.com>
Sent: Sunday, March 08, 2009 2:54 PM
Subject: Re: [TenTec] NEW Orion II/2.041XL Bug? Red Scan With Vertical
LinePatterns
The radio had been running on Rx for a few hours, 20 and 80 meters. The
80m
band was dead, mostly just local line noise.
I am now getting the normal white spectrum, but now behind it the entire
scan screen (up to the blue marker, is filled with red, first solid red,
then alternating red/black that starts at the top and walks downward,
then
solid red again. Occasionally the white spectrum trace will wipe itself
away from right to left. Is this what you folks are seeing, or is this
new?
By turning sweep off and on again it began working correctly.
Previously I had only seen this as a brief red spectrum trace (the white
trace disappears for a half second or so), and I thought this was what
you
were seeing. Just before this new phenomenon started, I was tuning and
happened to catch the spectrum in a "red only" trace...and it froze in
all
red color as long as I would turn the tuning knob.
I took some photos at: http://s685.photobucket.com/albums/vv219/N4BE/
Jim N4BE
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec