Re: [TenTec] Corsair II / 263 VFO Question

["Gary Smith" <Gary@doctorgary.net>]

And without that jumper you will have the issue you're describing.
Gary
KA1J

> Jerry's correct - you need the Pin 2 to Pin 6 jumper to enable the 
> internal Corsair PTO.
> 
> Steve G3TXQ
> 
> Dr. Gerald N. Johnson wrote:
> >
> > Needs a jumper on the Accessory socket. Pin 2 to 6 according my my
> > Corsair II manual.  Lower left corner of the block diagram page.
> >
> > 73, Jerry, K0CQ
> >
> > _______________________________________________
> > TenTec mailing list
> > TenTec@contesting.com
> > http://lists.contesting.com/mailman/listinfo/tentec
> >   
> 
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
>