K7wpz -
I enjoyed your satire very very much. So much that I have saved it.
Unfortunately, I am still using an OMNI 6+ doctored with a 600 Hz front end
roofing filter that I have found to be suberb,
and a Paragon II that does everthing I ever wanted in a general coverage
rig. Guess I will not pile them up in a corner
and revert to an old homemade one tube regenerative receiver and a sardine
can Pierce oscillator for a rig after all.
Thank you for your genuine humour, OM, it was good stuff.
73 - Don, ve1bn@eastlink.ca.
----- Original Message -----
From: <k7wpz@aol.com>
To: <tentec@contesting.com>
Sent: Wednesday, February 25, 2009 12:51 AM
Subject: Re: [TenTec] How many STILL waiting
Oh my gosh. All of these comments are so true. I did not realize how
crappy by Orion 1 and Orion 11 were until I read all of these comments on
the reflector. As a result, I boxed up both of these radios and set them
in a corner until all of the promised updates were released. How could I
have been so misled? In addition, I never realized how crappy my FT-2000D
was until I read the truth in all of these comments on the reflector. So,
I boxed it up and set it in the corner on top of the Orion 11. When will
these promised Yaesu updates arrive? In addition I learned that the
display on my FT-1000 MP Mark V was too dim, and the selectivity was
inadequate, without a slug of additional filters. So, I boxed it up and
set it on top of the FT-2000D. Maybe there will be an after-market update
for this disappointing, hard-to-view rig. Then, I learned that my Omni VII
was an inadequate transceiver because the sweep was sophomoric and, well,
it was a rig for newbie’s and not adequate for professional amateurs. So,
I boxed it up and set it on top of the FT-2000D, hoping for some TenTec
upgrade. They owe me. Then, of course, I had a problem with my IC-7700 and
had to send it back to ICOM service in Seattle. Obviously not ready for
prime time. Fortunately, I was able to box it up and set it on top of my
Omni VII before I suffered from the horror of trying to use such a crappy,
refurbished radio. I went for my IC-7000 but, then, I found out on the
reflector
that the audio sucked unless I sent off my mike for some sort of retrofit.
Phew, close one. Fortunately, I still had the box and I was able to pack
it up until there was some sort of obligated update. Thank goodness I
still had my Heathkit AT-1 transmitter and Hallicrafters S-38C. And, by
gosh, I haven’t seen any informative bashing on the associated reflectors
on this gear. So, I and my 6L6 are smoking my crystal-controlled, cw
frequencies. There is no way I will use any of this other crappy equipment
until I get the updates I demand and deserve.
By the way, I am taking down my new Dream Beam 36 and replacing it with a
20 Meter dipole. I learned that the spindles may break and Stepper never
answers any e-mails. Just in time, I am sure. Back to reliable copper
wire. At last, I am happy with my hobby. By the way, does anybody have a
spare 40 meter crystal, or, possibly, a Gonset 2 Meter Communicator. I
haven’t heard any informative updates on that fine piece of equipment
lately.
Respectfully,
David w8udx first licensed as wn8udx in November, 1949
-----Original Message-----
From: John Simon <jrsimon@ozemail.com.au>
To: Discussion of Ten-Tec Equipment <tentec@contesting.com>
Sent: Tue, 24 Feb 2009 7:14 pm
Subject: Re: [TenTec] How many STILL waiting
Well being a newcomer to TT I've only had my Orion II for about six months
nd my second-hand Argonaut V for about four months, will that allow me to
ave a say?
ell my main complaint=2
0is that my Orion II won't make my morning coffee for
e, nor will the Argonaut!
ut they certainly pull out the signals and consistantly out perform my
ther radios with similar antennae.
73, John de VK2XGJ
ometimes I pretend to be normal, but it gets boring.
So I go back to being me!
---- Original Message -----
rom: "Ron Zond" <k3miy@csonline.net>
o: "Discussion of Ten-Tec Equipment" <tentec@contesting.com>
ent: Wednesday, February 25, 2009 12:52 PM
ubject: Re: [TenTec] How many STILL waiting
Hi
As a TenTec owner for 13 years, I dont't bitch; I chuckle.
I am glad to see that folks have concerns, and want them resolved.
Be patient; they will be resolved.
Ron
K3MIY
-----Original Message-----
From: tentec-bounces@contesting.com
[mailto:tentec-bounces@contesting.com]On Behalf Of Charles Harpole
Sent: Tuesday, February 24, 2009 8:26 PM
To: Ten Tec List
Subject: [TenTec] How many STILL waiting
OK ok I know everyone, and I do mean EVERYONE,
is "still waiting" .. How many Ten Tec owners does it
take to bitch repeatedly on TT reflector,
answer--- ALL of them.
Charles Harpole
k4vud@hotmail.com
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
---------------
----------------------------------------------------------------
No virus found in this incoming message.
hecked by AVG - www.avg.com
ersion: 8.0.237 / Virus Database: 270.11.3/1970 - Release Date: 02/24/09
3:35:00
_______________________________________________
enTec mailing list
enTec@contesting.com
ttp://lists.contesting.com/mailman/listinfo/tentec
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|