On Tue, 2009-02-24 at 16:25 -0500, Doug Smith wrote:
> My Father Don VE3IYA says that his Triton IV that was working w/ low output
> on 10M is now not working in TX. As soon as you hit PTT in SSB, the key in
> CW or go to LOCK mode it shuts the TT 262G down. After a few seconds and a
> power cycle on the 262G it will come back to receive. This happens
> regardless of drive setting and YES it is into a known good dummy load.
>
>
>
> We have not had the covers off yet but I suspect the 80284 SWR ALC board
> will need to be looked at as well as the 80276 Final Amp and the 80280
> Control Board. So what do the experts on here say? We are just thinking out
> loud before diving in.
>
>
>
> Doug VE3IYB EN93ui ~ 60 miles SW of Toronto, Ontario, Canada Eh?
>
Power supply shutting down at too low a current?
73, Jerry, K0CQ
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|