TenTec
[Top] [All Lists]

Re: [TenTec] Doorknobs needed - Was: Ig drift on amps

To: <Gary@doctorgary.net>, "Discussion of Ten-Tec Equipment" <tentec@contesting.com>
Subject: Re: [TenTec] Doorknobs needed - Was: Ig drift on amps
From: "Bob McGraw - K4TAX" <RMcGraw@Blomand.net>
Reply-to: Discussion of Ten-Tec Equipment <tentec@contesting.com>
Date: Mon, 9 Feb 2009 21:52:22 -0600
List-post: <mailto:tentec@contesting.com>
Surplus Sales of Nebraska has some of them.
Fair Radio Sales has some of them.

Check E-Bay for some of them.

73
Bob, K4TAX

----- Original Message ----- From: "Gary Smith" <Gary@doctorgary.net>
To: "Discussion of Ten-Tec Equipment" <tentec@contesting.com>
Sent: Monday, February 09, 2009 7:29 PM
Subject: [TenTec] Doorknobs needed - Was: Ig drift on amps


It appears I likely need to replace at least some of the padding capacitors in the tank on my 425 to stop the Ig drift on the lower bands. To do a clean sweep, what I need to replace are the following.

A. (C6, C7) Two 1000pf @ 5KV series 858s doorknobs

B. (C17)     One 500pf @ 5KV series 858s doorknob

C. (C18, C20) Two 300pf @ 5KV series 858s doorknobs

D. (C15)     One 400pf @ 15K Series HEC HT57 doorknob

E. ( C16) One 270pf @ 2KV disc: Ceramic?/Mica? which is about 1"x3/32" and is glossy yellow. On the side it reads:

RMC   270    J
2KV    P     3


I would like to change "E" to an 858 series doorknob, making it a 270pf @ 5KV series 858 doorknob.

The Drifting Ig issue is really a problem on the low bands and I'm concerned about damaging the tubes. If you have any of these caps in as new condition available, please contact me off list.

Thanks!

Gary
KA1J
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec



<Prev in Thread] Current Thread [Next in Thread>