[TenTec] Rebuild 509 PTO

[<w1ioo@cooledge.com>]

I have the rebuild kit from TenTec. Following the directions everything was
going fine till I had to remove the ball bearings. They won't come out. I
have tried alcohol and Grease Lighting. This product seems to melt the
grease. No luck. They just seem to be stuck in the brass. I was thinking of
a little heat from a soldering iron might loosen them. Would like some ideas
before I destroy it. Thanks in advance.

Wally w1ioo  

_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec