Re: [TenTec] Problem (reboot) with my Orion II when I switch it on

[Alan Sewell <alan.n5na@gmail.com>]

Sounds like it could be the power distribution board.  See this thread.

http://lists.contesting.com/_tentec/2007-11/msg00073.html

73,

Alan  N5NA

http://www.tentecwiki.org



Cedric Baechler wrote:
> Hello,
> I have the following problem with my Orion II:
>
> When I start it by using the switch on/off button the Ten-Tec logo 
> appears, then the normal screen (with frequency, sweep, ..) for a few 
> seconds then it reboots itself. This can happen 5-6 times until the 
> normal screen stays and the Orion is ready to use. Sometime during the 
> boot process and when the normal screen appears I see a single 
> horizontal white line on the screen!!
> Before I contact Ten-Tec, has someone had this problem previously and 
> can help me?
> 73, Cedric HB9HFN
>
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
>
>