| To: | Discussion of Ten-Tec Equipment <tentec@contesting.com> |
|---|---|
| Subject: | [TenTec] FS: Panel Extrusion for Omni/Paragon |
| From: | Joe Roberts <jroberts@io.com> |
| Reply-to: | Discussion of Ten-Tec Equipment <tentec@contesting.com> |
| Date: | Wed, 30 Jan 2008 16:31:36 -0500 |
| List-post: | <mailto:tentec@contesting.com> |
FS: Panel Extrusion for Omni/Paragon. Bought for a Paragon but looks like it will work for Omni V and VI also. Never used...purchased from Ten Tec butin the meantime I brushed out the scratches in the old one to my satisfaction with abrasive pads. $20 + USPS on 1 pound from 23185 Not sure how much TT gets for this part so if I'm robbing you, let me know! 73 Joe N5KAT _______________________________________________ TenTec mailing list TenTec@contesting.com http://lists.contesting.com/mailman/listinfo/tentec |
| <Prev in Thread] | Current Thread | [Next in Thread> |
|---|---|---|
| ||
| Previous by Date: | [TenTec] ORION II CW pile up readability, Merle Bone |
|---|---|
| Next by Date: | Re: [TenTec] FS: Inrad CW roofing filter (no board!) #763, Vaughan, Robert J |
| Previous by Thread: | [TenTec] Samuel F. B. Morse III W^FZZ on improving code speed, Ronald C. McConnell |
| Next by Thread: | Re: [TenTec] Jupiter w A/T ettings for Digital (PSK31)Communications, Henry Mackey |
| Indexes: | [Date] [Thread] [Top] [All Lists] |