I think you need to turn up the mic gain and have either the data
connection or the mic connection selected in the menu according to where
you inject the signal. If i remember correctly, the mic gain controls
both inputs.
Paul (N6MYA)
On Tue, 2008-01-29 at 19:19 +0000, jimimaxi2@comcast.net wrote:
> I have problems with power on my screen dropping to zero as I transmit in
> digital.
> I tune to 1.0.0. My power is close to 30% which translates to about 20-23
> watts on the screen. Mic gain is zero. TX Filter BW is at 1050. Audio source
> is at line. Speech Proc is at 0. Mic Boost is at 0.
> I use a Donner Digital Interface to a USB port with a separate serial cable
> connecting the PC to my Jupiter for rig control via HRD. I use Digital Master
> 780 for the digital side.
> At times I get a clean output (TX and ALC light up), but at other times I
> drop to zero on the sceenand only the TX light appears. When this occurs a
> receiver near my desk shows nothing. I can return to a good watt output by
> increeasing Mic Boost to 12db.
> Does anyone know if any of my settings are wrong? Or any other help I may
> need.
> Jim
> KC2ROF
>
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|