Connect the output of your external keyer to the black PTT connector of the
accessory connector cable. Turn off your sidetone on your external keyer.
You will hear both receive signals and your sidetone in the headphones.
Carl Moreschi N4PY
121 Little Bell Drive
Bell Mountain
Hays, NC 28635
----- Original Message -----
From: "RM" <royalct@inr.net>
To: <tentec@contesting.com>
Sent: Monday, January 21, 2008 9:14 AM
Subject: [TenTec] Headphone Monitoring of Sent CW on Orion
> Ok, I have an Orion II and getting back in to CW after many years.
>
> How does one monitor sent CW via headphones plugged into the Orion with an
> external keyer?
>
> I have not found any discussion in the Orion's Manual, which addresses
this.
>
> This is very important that I hear both receive and sent code through the
> headphones, plugged into the Orion, as the 'natives' (young adults and
wife)
> of the house are about to throw me outside into the snow.
>
>
> Ron / NU1U
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|