Ivin:
The allen wrench size is .050". I have also used a 1.3mm, which is .052".
The main concern is to get a good quality allen wrench, as the El Cheapo
imported wrench's, such as Harbor Freight, etc., are usually soft, and fairly
easy to round off the corners.
"73" Dub
At 08:51 AM 1/13/2008, you wrote:
HI, the resonate control moves a slug up and down and as time goes on if
becomes subject to gravity. In the past I have taken the know off and
placed a felt washer behind the know to create a little friction between
the knob and the face plate. The allen is small and they do exist.
Ernie
N1SW
Ivin Flint wrote:
> The "Resonate" knob moves up and down and side to side
> a lot. I think maybe the nut behind the knob needs
> tightened but I am having trouble finding an allen
> wrench small enough to loosen the set screw.
>
> I wondered if anyone else has had this trouble and
> what is causing it. I also would like to know the
> alen wrench size for the set screws on the knobs.
>
> Thanks
> Ivin W9ILF
>
>
>
____________________________________________________________________________________
> Be a better friend, newshound, and
> know-it-all with Yahoo! Mobile. Try it
now. http://mobile.yahoo.com/;_ylt=Ahu06i62sR8HDtDypao8Wcj9tAcJ
>
>
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
>
>
>
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
--
J. W. (Dub) Thornton K5DUB
Minco, OK.
|