Jim,
Assuming they are press-in, you might check for oxidation on the
pins/sockets. (But you've likely already done that...)
Aside from that, I'd wonder if it worked okay in your friend's rig.
Best of luck.
73,
Bernie
In a message dated 12/22/2007 2:43:45 P.M. Central Standard Time,
jim-g4ppg@blueyonder.co.uk writes:
Recently I acquired a 500 Hz cw filter from a friend who was parting
with corsair 2 to a fone operator
I fitted this filter to my Corsair as per the instruction in the
manual, the results have been disappointing
I find that when I switch in the 500hz filter an S9 signal will drop
to as low as S1 any help in resolving
This problem would be most welcome .
Thanks 73 Jim G4PPG
**************************************See AOL's top rated recipes
(http://food.aol.com/top-rated-recipes?NCID=aoltop00030000000004)
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|