If you look at the schematic for the Omni V in the area of the RX ant slider
switch, there is an easy way to bring out the receive antenna connection to
a second receiver. There is even a hole in the back of the Omni V with a
plastic plug in it that can be removed to put in phono jack in it for this
connection.
You would still need to make a mute circuit for the rx320 speaker. My docs
show how to do this. You can use the Omni V amp out line to energize this
mute relay while transmitting.
Carl Moreschi N4PY
121 Little Bell Drive
Bell Mountain
Hays, NC 28635
----- Original Message -----
From: "Rick Denney" <rick@rickdenney.com>
To: <tentec@contesting.com>
Sent: Wednesday, December 19, 2007 11:38 PM
Subject: [TenTec] Basic advice on dual receive
> I'm facing a couple of weeks of enforced downtime following surgery in
> a couple of days, and I've decided it's time to get my dual receive
> capability working. I have an Omni V.9 for which I have not yet
> established computer control, and an RX-320 which I've not yet even
> powered up. I also have control software from Carl Moreschi that will
> operate both together, using the RX-320 as a second receiver. I want
> to use the same antenna for everything.
>
> Just thinking it through, I'll need a way to share the antenna that
> isolates the RX-320 when the Omni is transmitting to protect it. Is
> this provided by Carl's software, using some internal antenna switch
> in the RX-320? Do I need a separate piece of hardware, say an RF
> relay?
>
> I'm also expecting to have to mix the headphone outputs so that I can
> continue to use my Heil headset. I'm looking at the Dunestar two-radio
> headphone mix and switch. Does that sound like the right approach?
>
> I have looked through the materials Carl sent with his software but it
> doesn't have much on how to set up the station to use that feature. I
> haven't yet really dug into it--that's an activity for my enforced
> vacation. But I want to get anything I need ordered now so I don't get
> stuck.
>
> Thanks for any advice.
>
> Rick, KR9D
>
>
> ---
> Richard W. Denney, Jr. PE|Iteris, Inc.
> Associate Vice President |107 Carpenter Dr. Ste 230 | 703.925.3819
> rwd@iteris.com |Sterling, VA 20164 |Fax 703.471.1757
>
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|