Hi Pete
Did you try a power on reset of the box?
My Omni VI + 160 meter band went south and ten-tec said to try that first
and it fix it.
We tend to forget that it is a computer controlled box.
John Cox KC0YAI
Bona, Missouri
----- Original Message -----
From: "Peter Inskeep" <pinskeep@yahoo.com>
To: <tentec@contesting.com>
Sent: Friday, December 14, 2007 1:51 PM
Subject: [TenTec] Omni VI Plus (564) 10 meter xmit dead
As last weekend's 10 meter contest started I discovered that my Omni VI +
10 meter transmit is "dead." The receive may be diminished as well, but I
am not sure of that. I quickly switched to another rig.
When the rig is turned on from cold, ie., power supply turned off until
rig turned on, I get about 40 watts on both the internal meter, and on my
tuner's meter. This quickly drops to virtually zero, within seconds.
All other bands work fine. All four sections of the 10 meter band are
dead. Ie., 28.0 to 28.5, 28.5 to 29.0, etc.
I have pulled the rig apart. I suspect that the problem is on the Xtax
Osc. - L.O. Mixer board (81595). This board is located in the box under
the 81595SM and 82870 boards on the top left side of the rig. It contains
the band crystals and a whole bunch of switching diodes, among other
things.
Thus, it is almost impossible for me to test anything with the rig
running, as I have to remove those two boards and the aluminium plate to
get at the Mixer board.
I suspect the L.O. Mixer board because it seems to be the one place where
10 meter signals are completely separated from other band signals. In
fact, I am most suspicious of Q4 and/or Q5 on that board. I will replace
them to see if that does it.
I have checked diodes, in circuit, until my eyes are crossed. I have
checked solder traces until my eyes are recrossed. I've found nothing
that looks bad, and nothing that does not check continuity with my vtvm.
Having bored you will all of the above, if you are still with me, I have
two questions.
First, has anyone had the same symptom on their Omni VI Plus? If so, can
you suggest a fix.
Second, is there some other circuit where all four of the 10 meter
circuits are separate that I have not been able to discover?
I have not pulled the front panel off to see if the 10 meter button is
"broke." I think not because, first, it enters the "9" digit without
fail. Second, it does kick in 10 meters when the rig is cold, and the
display does go to 10 meters.
Finally, I know that the intelligent thing to do is to box it up and send
it to Ten-Tec. They will not only fix this problem, but reallign it and
make it better than new. If the two transistor replacements don't do it,
and no one on the reflector has a solution that I can implement at home, I
will send it back to Ten-Tec after the holidays are over and UPS is back
to moving cartons instead of chucking them due to the holiday rush.
I am not a frequent poster to the reflector, but I do monitor it, so, if
you can offer any suggestions, I will be most appreciative. My XYL's
solution to this is to send the rig back to Ten-Tec in trade for an Omni
VII. Not a bad idea!
Thanks,
Pete, no2d.
---------------------------------
Never miss a thing. Make Yahoo your homepage.
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|