Hello Carl:
It was enjoyable meeting w/ you again at the Ten Tec Hamfest this fall.
I have a Pegasus for the last 4 years but never had it hooked up. Planning
on doing this by first of year. Would like to have your latest software but
didn't see any ordering on line when I went to your web page. How do I get
this done??
Thanks for your help.
Ralph Howes
W8BVH
----- Original Message -----
From: "Carl Moreschi" <n4py@arrl.net>
To: <Ten-Tec-Omni-VII@yahoogroups.com>
Cc: "tentec" <tentec@contesting.com>
Sent: Monday, December 10, 2007 9:10 AM
Subject: [TenTec] N4PY Pegasus Version 2.39 now available
I have just released version 2.39 of my N4PY Pegasus control program. This
version has several enhancements. The biggest one for the Omni VII now
adds
support for all the audio improvements in firmware version 1.024. The
transmit and receive audio over Ethernet is now much clearer and better
than
in the past. See www.n4py.com for further details.
Carl Moreschi N4PY
121 Little Bell Drive
Bell Mountain
Hays, NC 28635
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|