You must configure N3FJP for a tentec pegasus even though you actually have
an Orion. This will cause N3FJP to not use a serial port at all, and
instead communicate to the N4PY program through the tentec file interface.
You must also specify in the N3FJP program, the folder where the N4PY
program is installed. The default location for the N4PY Orion program is
c:\n4pyor.
Carl Moreschi N4PY
121 Little Bell Drive
Bell Mountain
Hays, NC 28635
----- Original Message -----
From: "VinceSantis" <vsantis@earthlink.net>
To: "Tentec" <tentec@contesting.com>
Sent: Sunday, December 09, 2007 12:52 PM
Subject: [TenTec] N4PY and N3FJP log
> HI,
>
> Is anyone using N4PY software and N3FJP log with their Orion? I so, can
you
> share how you set it up to get by the port conflict?
> Thanks,
> Vince Santis, N1VS
> Winsted, CT
>
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|