Just plug your keyer into TenTec Amp "key in" and use "key out" to Elecraft
"Key" jack. Let the amp key the radio....
Best regards,
Gary - AB9M
CSM(r) G.L.Huber
9679 Heron Bay Road
Bloomington, Illinois 61704
(309)662-0604
www.csm-gh.com
csm-gh@www.csm-gh.com
gary.huber@us.army.mil
ab9m@arrl.net
www.csm-gh.com/mytrike.htm
www.csm-gh.com/75thRepoDepo.htm
----- Original Message -----
From: "Allan Taylor" <k7gt.cw@gmail.com>
To: <tentec@contesting.com>
Sent: Tuesday, December 04, 2007 8:12 PM
Subject: [TenTec] relay delay in Tentec QSK amps
> I am considering purchasing an Elecraft K3. This radio does not,
> unfortunately, have a QSK keying loop to directly
> interface with my Tentec amps. Does someone on this reflector know the
> delay in the collective relays of either/both the
> Tentec Titan (original) or Hercules II amps? This would be useful in
> setting up QSK in an alternative way--without a
> keying loop. I would guess on the order of 5 msec or so, but would
> like hard numbers to mull over.
>
> --
> 73 Allan K7GT
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
>
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|