| To: | Discussion of Ten-Tec Equipment <tentec@contesting.com> |
|---|---|
| Subject: | Re: [TenTec] Omni VI Tuning Knob Speed |
| From: | Ed <w3nr@comcast.net> |
| Reply-to: | Discussion of Ten-Tec Equipment <tentec@contesting.com> |
| Date: | Fri, 23 Nov 2007 13:24:14 -0500 |
| List-post: | <mailto:tentec@contesting.com> |
Hamdriver66@aol.com wrote: Just got an Omni VI, '04 production with level one upgrade done by TenTec. Trying to reset tuning knob speed on CW, but after repeated attempts following the manual's procedure, it stays at 5.0 ratio. Anyone else had this problem and is there a new/revised procedure? Thanks for any help.Mike/K4KJC Mike, option1 only provided the DSP part, you need option3, Ed W3NR |
| <Prev in Thread] | Current Thread | [Next in Thread> |
|---|---|---|
| ||
| Previous by Date: | Re: [TenTec] ORION II and blind hams, Ed Malmgren |
|---|---|
| Next by Date: | Re: [TenTec] Orion 1 slow to reach full output/muffled CW, Duane Calvin |
| Previous by Thread: | [TenTec] Omni VI Tuning Knob Speed, Hamdriver66 |
| Next by Thread: | Re: [TenTec] Omni VI Tuning Knob Speed, Hamdriver66 |
| Indexes: | [Date] [Thread] [Top] [All Lists] |