| To: | tentec@contesting.com |
|---|---|
| Subject: | [TenTec] Orion 1 slow to reach full output/muffled CW |
| From: | Jon Zaimes AA1K <jz73@verizon.net> |
| Reply-to: | Discussion of Ten-Tec Equipment <tentec@contesting.com> |
| Date: | Thu, 22 Nov 2007 21:24:19 -0500 |
| List-post: | <mailto:tentec@contesting.com> |
When I key my Orion 1 (v. 1.373b5) the red LED at first lights but then
goes out as I key, and the signal sounds muffled on another RX.
When I hold the key down and watch an output meter, the output starts out low and then slowly rises to full output (and the LED comes on). Any ideas what's happening? Adjusting the keying rise/fall has no effect on this problem. 73/Jon AA1K |
| <Prev in Thread] | Current Thread | [Next in Thread> |
|---|---|---|
| ||
| Previous by Date: | [TenTec] FS RX320D, Marty Hartwell |
|---|---|
| Next by Date: | [TenTec] Omni VI Tuning Knob Speed, Hamdriver66 |
| Previous by Thread: | [TenTec] FS RX320D, Marty Hartwell |
| Next by Thread: | Re: [TenTec] Orion 1 slow to reach full output/muffled CW, Duane Calvin |
| Indexes: | [Date] [Thread] [Top] [All Lists] |