TenTec
[Top] [All Lists]

Re: [TenTec] Omni VII Temperature Control

To: <alan.n5na@gmail.com>, "Discussion of Ten-Tec Equipment" <tentec@contesting.com>
Subject: Re: [TenTec] Omni VII Temperature Control
From: "Bob McGraw - K4TAX" <RMcGraw@Blomand.net>
Reply-to: Discussion of Ten-Tec Equipment <tentec@contesting.com>
Date: Sun, 14 Oct 2007 20:57:35 -0500
List-post: <mailto:tentec@contesting.com>
Alan:

Thanks for the info. I needed to update the operating version from 1.019 to 1.021. Also did a update on the Boot Loader from 1.003 to 1.004 which is REQUIRED. Updates were very easy and very fast and successful!

Thanks

73
Bob, K4TAX


----- Original Message ----- From: "Alan Sewell" <alan.n5na@gmail.com>
To: "Discussion of Ten-Tec Equipment" <tentec@contesting.com>
Sent: Sunday, October 14, 2007 6:26 PM
Subject: Re: [TenTec] Omni VII Temperature Control


Yes, there is.  Check the firmware history.

Version 1.012
Add Internal Temperature Control of approximately 70deg C

Version 1.014
Increase Over Temp Shutoff Temperature

When 1.012 came out there were complaints of it shutting down when
operating normally so the shutoff temp was increased in version 1.014.
Maybe it needs to be bumped up a little more!

This was apparently added to meet some European requirements.

73,

Alan  N5NA

http://www.tentecwiki.org



Bob McGraw - K4TAX wrote:
Is there a high temperature TX shutdown in the radio?

73
Bob, K4TAX
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec


_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec




<Prev in Thread] Current Thread [Next in Thread>