| To: | "Discussion of Ten-Tec Equipment" <tentec@contesting.com> |
|---|---|
| Subject: | Re: [TenTec] reduce RF Gain on a Scout? |
| From: | "Stuart Rohre" <rohre@arlut.utexas.edu> |
| Reply-to: | Discussion of Ten-Tec Equipment <tentec@contesting.com> |
| Date: | Wed, 3 Oct 2007 14:43:02 -0500 |
| List-post: | <mailto:tentec@contesting.com> |
Ken,The RF gain is set by a fixed resistor. The mod, substituted a pot for that resistor. If you are into the radio to change a resistor, you might as well make it an added pot on the back panel, if you don't think you will change it much. Flat cable can be used to bring the wires into the board. -StuartK5KVH |
| <Prev in Thread] | Current Thread | [Next in Thread> |
|---|---|---|
| ||
| Previous by Date: | Re: [TenTec] dual receive, Duane - N9DG |
|---|---|
| Next by Date: | Re: [TenTec] reduce RF Gain on a Scout?, Ken N9VV |
| Previous by Thread: | [TenTec] reduce RF Gain on a Scout?, Ken N9VV |
| Next by Thread: | Re: [TenTec] reduce RF Gain on a Scout?, Ken N9VV |
| Indexes: | [Date] [Thread] [Top] [All Lists] |