Re: [TenTec] Argo V Serial Port

["Chip Morgan" <wmorgan@outdrs.net>]

Jeff,

I had the same problem and Ten-Tec sent out a new connector; however, when I
started to take the rig apart to replace the connector I found the shell of
the DB-9 was a seperate piece.  So just remove the jack screw posts from the
connector and whatever else holds that board to the rear panel and reverse
the shell of the DB-9.  Re-assemble and you're done.  Took all of about 5
minutes when I figured out what happened.

73,

Chip N3IW


_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec