| To: | "tentec" <tentec@contesting.com> |
|---|---|
| Subject: | [TenTec] Help Omni Vi+ display |
| From: | "MICHAEL SOUHRADA" <wb9iog@msn.com> |
| Reply-to: | Discussion of Ten-Tec Equipment <tentec@contesting.com> |
| Date: | Mon, 20 Aug 2007 00:36:18 -0500 |
| List-post: | <mailto:tentec@contesting.com> |
Hope someone can shed some light on this event. My display on 160 meters ONLY is way off. It shows 73.965 ??? All the others are just fine. Been studying the manual (not much help with out a block diagram) and reset a few connectors in the line. No luck. Has this happened to other Omni VI+ or similar operators? Really odd. I've had displays go sour but not quite like this. Mike Iowa _______________________________________________ TenTec mailing list TenTec@contesting.com http://lists.contesting.com/mailman/listinfo/tentec |
| <Prev in Thread] | Current Thread | [Next in Thread> |
|---|---|---|
| ||
| Previous by Date: | Re: [TenTec] Want: Corsair II, Paul Gates, KD3JF |
|---|---|
| Next by Date: | Re: [TenTec] Paragon, computer & CW Keying, Vic Klein |
| Previous by Thread: | [TenTec] Want: Corsair II, dbp |
| Next by Thread: | [TenTec] FS: microHAM USB <-> radio interfaces, Jerry.Van |
| Indexes: | [Date] [Thread] [Top] [All Lists] |