Paul DeWitte K9OT wrote:
> Bob, I had a simalar problem a few years ago with my Omni VI+.
>
> I was told that it might be dirty connectors and you could check it out by
> switching with the rit. I dont remember the numbers on the wires but that
> was not the problem anyway. The problem was a dirty connector where it went
> onto the encoder.
>
> Took it off and cleaned it and has been working FB ever since. That tip was
> from Dave,K1FK. It saved me from buying a new encoder.
>
> Good luck
> 73 Paul K9OT
>
> _______________________________________________
> Could anybody give me instructions on how to get the keypad panel off
the fascia plate of my Omni V? I need to replace the digital encoder. I
think the connector is 93.
I see there's a screw in each corner of the front panel. Undoing them
presumably releases the front panel. Does the key pad panel then come
loose at the same time?
73
Bob
MM0RKT
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|