Is there any Ten Tec service department in Europe?
If not call Ten Tec here in the states. They should give you a place to
start looking anyway.
73, Mike
----- Original Message -----
From: "Bob Towers" <mm0rkt@beeb.net>
To: "Discussion of Ten-Tec Equipment" <tentec@contesting.com>
Sent: Sunday, July 29, 2007 10:34
Subject: [TenTec] Frozen display on Omni V.9
>I have noticed in the last month or so that the display on my Omni V.9
> freezes up after about 20 minutes operation. Recently it has got worse
> and the display is frozen when I switch on the rig. Rotation of the
> tuning control does nothing except change the last digit on the display
> by +/- 1 (=100Hz). All other controls work correctly.
>
> I am able to tune the rig using CAT control, by the way. Disconnection
> of the CAT serial link makes no difference.
>
> Any help on this would be much appreciated.
>
> 73 and thanks in advance
>
> Bob Towers
> MM0RKT
>
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
>
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|