Re: [TenTec] Frozen display on Omni V.9

[Bob Towers <mm0rkt@beeb.net>]

Bob McGraw - K4TAX wrote:
> Could this be one of those "3rd party" software glitches?
>
> A full reset may correct the issue or maybe return to the original Tentec 
> issued software which did not encounter the concern.
> 73
> Bob, K4TAX
>
> Thanks, Bob, for your suggestions. The full reset didn't do the trick, 
by the way.

I'm not sure about the software. The V -> V.9 mod involves replacement 
of the main EPROM ie a change of the firmware. There are enough V.9 
modded rigs out there to have shown up this problem already, if that had 
been the cause.
73

Bob
MM0RKT