Re: [TenTec] OMNI VI serial PTT

[Tod Glenn <n7wd@cordite.com>]

> Tod,
>
> I using a normal 9-pin to 25-pin serial cable from the PC to the Omni
> VI.  I think it is a "cross-over" cable but I'm not sure on that.   
> I can
> check if you wish.  I have mine set to 19200bps, 8 data bits, 1 stop
> bit.  You also need to set the software up for an Icom IC-735.  I've
> read that IC-703 may work also but I have not tried it.

I finally got it to work!!  You can test you serial connection by  
hooking up the cable, opening a term and then powering up the Omni  
while holding the FM key.
I did this, and it must have kicked something, because the connection  
now works.
----
Tod Glenn
N7WD
SKCC #1444
ARCI #12420
FISTS #12134
NAQCC #1283

n7wd@cordite.com