TenTec
[Top] [All Lists]

Re: [TenTec] Omni VII meter.

To: Discussion of Ten-Tec Equipment <tentec@contesting.com>
Subject: Re: [TenTec] Omni VII meter.
From: Ken Brown <ken.d.brown@hawaiiantel.net>
Reply-to: ken.d.brown@hawaiiantel.net,Discussion of Ten-Tec Equipment <tentec@contesting.com>
Date: Sat, 19 May 2007 11:39:02 -1000
List-post: <mailto:tentec@contesting.com>
Hi Mark,

I don't have an Omni VII, so I cannot give you an authoritative answer. 
I do have an idea though. It is a sort of "divide by zero problem". With 
an old fashioned SWR bridge, where you have to manually adjust the FWD 
reading for full scale with your rig putting out a constant carrier 
level, you don't have this problem. With an automatic SWR meter, there 
is either analog or digital electronics attempting to do the adjust for 
full scale on forward power routine all the time. When the forward power 
is zero, the gain for the reflected power reading is cranked up high.

k8vf_mark@centurytel.net wrote:
> 2) when using SWR for TX meter in SSB,  if I key the mic and DO NOT talk,
> the swr climbs up to 9.9:1 and stays there. As soon as I talk, it drops to
> the appropriate level.  Is this intentional, to advise that the mic is
> keyed?  or is it a function of the firmware?
>
> Any ideas?
>
>
>
>   

_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec

<Prev in Thread] Current Thread [Next in Thread>