Neal,
I must be missing something - where is the menu item for output
audio level? (I must be having a "doh!" moment!)
73, Duane
Duane Calvin, AC5AA
Austin, Texas
www.ac5aa.com
-----Original Message-----
From: tentec-bounces@contesting.com [mailto:tentec-
bounces@contesting.com]
On Behalf Of Neal Campbell K3NC
Sent: Wednesday, April 25, 2007 9:10 PM
To: Discussion of Ten-Tec Equipment
Subject: Re: [TenTec] Orion 2.060b Receive Audio levels down quite
a bit
Did you check the menu item for it to make sure its set to high? I am
sure you probably did, just wanted to ask the obvious!
Neal Campbell K3NC
nealk3nc@gmail.com
telnet to our DX Spotting clusters at: dxc.k3nc.com, ports 12001
and 23
"Devoted to Dogs: How to be your dog's best owner"
Great Dog Book at www.abrohamneal.com
On Apr 25, 2007, at 10:00 PM, Barry N1EU wrote:
On 4/26/07, Duane Calvin <ac5aa1@gmail.com> wrote:
I don't know if others are noticing this too, but the audio output
of the
Orion's 8-pin DIN rear connector seems to be down quite a bit from
the
last
version of the FW. On my DigiKeyer, I have to run the level control
almost
full out to see the same thing I saw with a 10 o'clock setting on
the last
level.
I notice that audio to the speaker and the headsets are also down
- on my
Heil Pro-Set I have to run the control at about 80% for normal
volume.
Something isn't right on this score.
Wasn't it about the same with v2.059 (i.e., it was a problem and
still is)?
73,
Barry N1EU
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec