I have both an Omni VI opt 1 and an Omni VI Plus and neither manual has
much to say. The plus manual says "You must verify the amplifier key input
requires only a low voltage dc connection to ground" The Vi manual doesn't
even have this note.
I like my transceivers very much but Ten-Tec's manuals leave a lot to be
desired.
I would suggest calling Ten-Tec service. They are very helpful.
When I get my shack finished I am going to run a Collins 30s-1 but will be
using a black box in between.
John Cox
Bona, Missouri
At 01:46 PM 4/16/2007, you wrote:
I just bought that OMNI VI opt 3 from Ten Tec. I am now searching the
arcives for info on how much current the VOX relay can handle. I have a
Drake L7 and the control circuit is 28 volts @ 50 ma. As a CW operator
that second filter position will soon be filled and used.
The OMNI VI opt 3 is replacing a 1977 Drake C line as my main rig however
the trusty Drake set will still be handy if needed!
Don
N4DJ
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
--
No virus found in this incoming message.
Checked by AVG Free Edition.
Version: 7.5.446 / Virus Database: 269.4.0/761 - Release Date: 4/14/2007
9:36 PM
--
No virus found in this outgoing message.
Checked by AVG Free Edition.
Version: 7.5.446 / Virus Database: 269.4.0/761 - Release Date: 4/14/2007 9:36 PM
|