TenTec
[Top] [All Lists]

Re: [TenTec] Orion II Firmware update...how soon?

To: "Discussion of Ten-Tec Equipment" <tentec@contesting.com>
Subject: Re: [TenTec] Orion II Firmware update...how soon?
From: "John" <brazos@rochester.rr.com>
Reply-to: Discussion of Ten-Tec Equipment <tentec@contesting.com>
Date: Thu, 5 Apr 2007 19:51:25 -0400
List-post: <mailto:tentec@contesting.com>
I have to disagree with you I also had a Icom 746 and not only was the rx audio poor but the noise reduction made everything worse . I leave the noise reduction on my Orion II on all the time and it never hurts the signal and most of the time it helps ! My major complaints are learning how to use the high and low cut with the pbt and bandwidth and those darn cheap feeling knobs ! ( vfo knobs not included ) I how ever can not fault the rx it is by far the best I have ever heard ! John kb2huk ----- Original Message ----- From: <k8jdc@sbcglobal.net>
To: <tentec@contesting.com>
Sent: Thursday, April 05, 2007 8:40 PM
Subject: [TenTec] Orion II Firmware update...how soon?


Doug,

     I've been an Orion owner since last fall and have made very few posts
to the list, but I'm going to agree with you on this count.  My previous
main rig was an Icom 746 and I never turned the NR off.  It really worked
great.  On my Orion, I never turn it on (using either V1 or V2 software).
I've experimented with lots of settings, but I've never found the NR to
perform up to my expectations.  So, it stays off.

     I also have to say I'm very surprised that there hasn't been a single
software release for the Orion in the 6 months that I've owned mine.  I
understand that the Omni VII has been the priority for TT, but I think some of the problems with 2.059 could be fixed with an interim release inside of
6 months instead of waiting for a major software release this far down the
road.

    It's a great radio and I'm happy to support Tentec, but I also hope to
see things improve sooner rather than later.

Dave
K8JDC

Grant, the NR on my 1000mp smokes the Orion II in every sense. The NR on my TS-2000 smokes the NR on the Orion II again in every sense. The bottom line is I don't care how tentec does it...but at least make it work i.e. enhance
the signal by removing the noise around it. This issue as with many others
has been going on way too long. I really enjoy the Orion II and it's
abilities. However, I am really getting tired of being ignored on what
appears to be a very common concern and that is attention from TenTec on
the
known issues with the Orion. I am glad for the Omni success, now make the
Orion owners a bit less regretful.

_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec


<Prev in Thread] Current Thread [Next in Thread>