Giuseppe:
Do the RIT and XIT controls work OK? When they are off does RIT and XIT in
the display for Main, and RIT for Sub all show "0"? This could be a
firmware problem or maybe the RIT/XIT encoder has gone bad. You may want to
try a Master Reset, or reload the firmware from the Ten Tec website.
Ron N6IE
www.N6IE.com
(Formerly N6AHA)
----- Original Message -----
From: "Giuseppe Crosta" <crosta@aero.polimi.it>
To: <tentec@contesting.com>
Sent: Monday, March 12, 2007 9:18 AM
Subject: [TenTec] Orion display readout
Hi Martin,
the RIT and XIT are obviously set at zero and this problem occur always
and in all modes.
At zero beat in CW the matching frequency is 100 Hz lower on my display
and the same occur in SSB mode.
If I use the 10 or 100 Hz step the the wrong display indication is still
present and I work always from front panel.
So, this is the situation.
Thank,
Giuseppe IZ2ABU
------------------------------------------------------------------------------------------------------------------------------------
AGUSTA-WESTLAND
a Finmeccanica Company
Giuseppe CROSTA
c/o Politecnico di Milano
Galleria del Vento - Wind tunnel facility
Via La Masa, 34
20158 Milano - Italy
Phone +39-02-2399.8057
Fax +39-02-2399.8274
E-mail crosta@aero.polimi.it
------------------------------------------------------------------------------------------------------------------------------------
Disclaimer :
This e-mail is strictly confidential and solely for the addressee. Agusta
S.p.A. does not give any representation or warranty as to the accuracy or
completeness of the contents of this e-mail, nor shall the company be
held liable to any person resulting from the use of any information
contained in this e-mail and shall not be liable to any person who acts
or omits to do anything in reliance upon it. If you are not the intended
addressee you must not use, disclose or copy this transmission; in this
case, please notify us immediately by telephoning:
+39-(02)-2399.8057
Thank you
Il presente messaggio deve intendersi strettamente confidenziale e
destinato esclusivamente al sopra riportato destinatario. Agusta S.p.A.
non garantisce l'esattezza e la completezza del messaggio così come
ricevuto e in ogni caso si ritiene esonerata da ogni responsabilità in
conseguenza di un'impropria utilizzazione del presente messaggio. Qualora
il messaggio Vi fosse pervenuto erroneamente, Vi è fatto divieto di usare,
diffondere o copiarne il suo contenuto. In tale caso Vi preghiamo di
volere immediatamente contattare il seguente numero telefonico:
(02)-2399.8057
Grazie.
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|