Thanks for the input Brent. To be clear, are you using the Ameritron QSK 5
with the Orion and 91B? I want to use this due to the noise produced by the
91B internal vacuum relays. The QSK 5 uses pin diodes and is "noiseless".
Thanks again........John K4NP
----- Original Message -----
From: "R. Brent Zook" <brent.zook@verizon.net>
To: "Discussion of Ten-Tec Equipment" <tentec@contesting.com>
Sent: Wednesday, February 14, 2007 3:39 PM
Subject: Re: [TenTec] Orion (I) and Alpha 91b using QSK 5
John, I use that exact pair at my place. Just use the regular "amp out"
to connect with the relay in the amp. You can set your relay delay in
the Orion to the very minimum possible. The 91b handles it extremely
well. --Brent N9HZ
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|