Hi Gary,
I use the Heil BM-10 http://www.heilsound.com/amateur/bm10.htm 99% of the
time on SSB.
I think I understand what you have said in your email.
I use a Heil Yaesu adapter that I purchased in approx. 1998 for a Yaesu
1000MP and it works well with the BM-10 now on the Orion II.
However, I do have to use chokes in the boomset cable just before it goes
into the Orion II on 80 meters because RF is getting into the mic line..
The RF in the shack is a no greater now than with the 1000MP which never was
a problem so I am wondering (wild guess) if the wiring in the Orion II.and
the adapter needs to be corrected as you suggested in your email to solve
this RF problem?
Would you suggest I take the Heil adapter apart and change the wiring where
on the plug where it plugs into the Orion II per your email information?
Many thanks and 73,
Lee Armitage N0LYW
970-234-8989
----- Original Message -----
From: "Gary Strong" <gjstrong@comcast.net>
To: "'Discussion of Ten-Tec Equipment'" <tentec@contesting.com>
Sent: Saturday, February 03, 2007 11:55 AM
Subject: Re: [TenTec] Heil headset for Orion II
As everyone has said, the Yaesu cable works but does not ground the unit
per
Ten Tec specs. Yausu connects both ptt ground and mic ground together, so
3
wires are used from rig end of connector to mic end. Ten tec specs that
the
ptt ground is separate from the mic ground, AND that the ptt ground is
used
for the shell of the microphone.
Heil makes this mod available in their Yaesu cables, however up until last
week they were doing the mod incorrectly. They were tying the mic
ground/shield to the mic shell. While most hams would never notice the
difference, I live by a very strong AM radio station. Hence, I had AM
radio
in my SSB audio (see my earlier post on this).
I took the mic end apart and disconnected the mic ground and re-connected
the ptt ground to the mic shell and everything now works great. I called
Heil on Friday and they basically said OOPs! They are now going to change
their cables to match the correct Orion II wiring.
Hope this all makes sense, and if not I'd be glad to explain further.
Gary
KO0Q
-----Original Message-----
From: tentec-bounces@contesting.com [mailto:tentec-bounces@contesting.com]
On Behalf Of Wayne King
Sent: Saturday, February 03, 2007 11:34 AM
To: tentec@contesting.com
Subject: [TenTec] Heil headset for Orion II
I getting ready to order a Heil Headset for my Orion II but I only see an
adaptor for a 4 pin mic which will work on my Omni VI+. Is there an 8 pin
adaptor for the Orion II? Heil's web site does not list one.
Wayne N2WK
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|