go grab the output of the capsule (R96),,,, before the preamplifier....
disconnect the orange and red lines going to the preamp board,
take one to the gnd mic line the shield...
take the other mic line and connect it to the white.... mic audio line,,,,
just get that pre out of the circuit,,,
it might pleasantly surprise you,,,,,
bill ny9h
http://www.shure.com/stellent/groups/public/@gms_gmi_web_ug/documents/web_resource/us_pro_526t_series2_ug.pdf
At 03:03 PM 1/26/2007, you wrote:
>I am using a Shure 526T Series II mic with a Corsair II.
>The mic clips signals if set over a 3.
>Here is question.
>On all amplified mic I have used in the past if you turn the mic gain all
>the way down it shuts off the mic.
>This is not the case on this Shure.
>I can turn it all the way down and still have a good signal out on the scope.
>Is that the way the Shures are set up or do I have a mic problem?
>I am going to take the battery out tonight and see if the scope still shows
>a signal from the mic.
>If it does I must have a bad mic right?
>If any of you guys have one of these mics could you let me know how yours
>works as to this problem.
>I would think the output should be 0 or close to it turned down to 1.
>
>Thanks in advance,
>Dan/N4VET
>
>_______________________________________________
>TenTec mailing list
>TenTec@contesting.com
>http://lists.contesting.com/mailman/listinfo/tentec
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|