The EQ settings were flat on both radios. Actually, there is no receive EQ
setting in the TS-870, and the receive EQ on the O2 V.2.037j does not work
on AM. Each receiver was fed to a Behringer UB1202 mixer (settings flat)
feeding a Sound Blaster Audigy 2 card in my laptop, also flat.
On your graph Martin, is the vertical axis time? If so, how much time is
being displayed? I'm not quite sure how to read that.
Ron N6IE
www.N6IE.com
(Formerly N6AHA)
----- Original Message -----
From: "Martin AA6E" <aa6e@ewing.homedns.org>
To: "Discussion of Ten-Tec Equipment" <tentec@contesting.com>
Sent: Tuesday, January 23, 2007 5:53 PM
Subject: Re: [TenTec] AM Receiver distortion in Orion II
> The second half is clear far better than the first, in my opinion. It's
> not a question of low-frequency response, but of distortion in the highs
> - almost like a little clipping, or maybe some other digital artifact.
>
> Ron should tell us what the Audio Eq. setting was, by the way.
>
> I ran a spectrum on the file with Spectrum Lab. The results (for
> several playbacks) are at http://aa6e.net/aa6e/images/capt0701232044.jpg
> . Carl was right that the "good" playback is much wider than Orion's.
> Orion's spectrum has a very sharp cutoff, but I don't think that's what
> I am hearing.
>
> It would be neat to try this on the Orion I comparing v1 and v2
> firmware, but I've got a few other things to do right now...
>
> 73 Martin AA6E
>
> Carl Moreschi wrote:
>> The Orion recording has more bass and less highs. With a 6 khz filter in
>> the Orion, the audio passband is 3 khz on each side of the carrier. I
>> would
>> expect this to sound bassy and have less highs. But the quality is
>> excellent. The 870 recording clearly shows that the bandwidth is much
>> greater than 3 khz which would only allow 1500 hertz of each side of the
>> carrier. I bet the 870 has a special AM filter that is in the 9 khz or
>> higher range that switches in automatically in AM. It is impossible for
>> the
>> 870 AM audio to sound like this with only 3 khz BW. Both audios are
>> excellent considering the BW.
>>
>> Carl Moreschi N4PY
>> 121 Little Bell Drive
>> Bell Mountain
>> Hays, NC 28635
>> ----- Original Message -----
>> From: "Ron Castro" <ronc@sonic.net>
>> To: "Ten Tec List" <tentec@contesting.com>
>> Sent: Tuesday, January 23, 2007 5:54 PM
>> Subject: [TenTec] AM Receiver distortion in Orion II
>>
>>
>>> One of the items on my "wish list" for the Orion II is to fix the AM
>> receive audio, which sounds to me like a problem in the DSP code that
>> causes
>> distortion and 'muddy' sound. It's most noticeable during selective
>> fades
>> that cause a serious clipping effect. Last night, I made an MP3 of a
>> local
>> AM radio station comparing the O2 to a TS-870, and sent it to TT service.
>> This morning, TT said they couldn't hear any difference between the two
>> receivers. Is it my ears or what? The link to the clip is below. The
>> O2
>> is the first 60 seconds and the 870 is the second 60 seconds. Bandwidth
>> on
>> the O2 is 6 kHz, while the 870 is 3 kHz, although as you'll hear, it
>> sounds
>> just the opposite!
>>> http://n6ie.com/OrionII_vs_870.mp3
>>>
>>> Can anyone besides me hear the difference?
>>>
>>> Ron N6IE
>>> www.N6IE.com
>>> (Formerly N6AHA)
>>> _______________________________________________
>>> TenTec mailing list
>>> TenTec@contesting.com
>>> http://lists.contesting.com/mailman/listinfo/tentec
>>
>> _______________________________________________
>> TenTec mailing list
>> TenTec@contesting.com
>> http://lists.contesting.com/mailman/listinfo/tentec
>
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
>
>
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|
