On Fri, 2007-01-19 at 14:31 -0500, John Huffman wrote:
<SNIP>
>
> The only downside is that the shaft of the new control is about half as big
> around as the 1/4" shaft of the old one. The old knob works fine, but its
> turns
> are not concentric. A shim would fix this.
Shaft adapter for 1/4" knob on 1/8" shaft. Mouser (www.mouser.com) 506-
KR1, 57 cents in single lots. I can't machine one for that.
>
> I have three controls left and one is spoken for. If anyone else wants one
> they
> cost $3.95 plus postage. Or, you can buy them from Electronix Express
> directly,
> but they have a $20 minimum. If you want one of mine, just drop me an email
> and
> we can figure out the best way to send it.
>
> 73 de K1ESE
> John
--
73, Jerry, K0CQ,
All content copyright Dr. Gerald N. Johnson, electrical engineer
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|