TenTec
[Top] [All Lists]

Re: [TenTec] Sidetone + RX Audio

To: "Discussion of Ten-Tec Equipment" <tentec@contesting.com>
Subject: Re: [TenTec] Sidetone + RX Audio
From: "Ron Castro" <ronc@sonic.net>
Reply-to: Ron Castro <ronc@sonic.net>,Discussion of Ten-Tec Equipment <tentec@contesting.com>
Date: Sat, 9 Dec 2006 08:35:44 -0800
List-post: <mailto:tentec@contesting.com>
That's the way it is supposed to work.  The side tone, the spot tone and the 
"centered" CW signal, when properly tuned in, all are the same pitch.

      Ron   N6IE
 www.N6IE.com
(Formerly N6AHA)

----- Original Message ----- 
From: "Eric Rosenberg" <wd3q@starpower.net>
To: "Ten Tec Mailing List" <tentec@contesting.com>
Sent: Friday, December 08, 2006 11:32 PM
Subject: [TenTec] Sidetone + RX Audio


> Two months after it came back from TT, I finally put the shack back
> together. The Orion came back with v2.xx firmware. No time to change it
> to anything else.
>
> I'm trying to match the pitch of a centered CW signal in the Writelog CW
> decoder with my sidetone. I noticed that when I changed the sidetone
> pitch, the RX audio shifted, too.  Is this normal (I was in LCW mode)?
> Is there a cure?
>
> Thanks,
>
> Eric W3DQ
> Washington. DC
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
>
> 

_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec

<Prev in Thread] Current Thread [Next in Thread>