TenTec
[Top] [All Lists]

Re: [TenTec] Noise Reduction Setting

To: "Discussion of Ten-Tec Equipment" <tentec@contesting.com>
Subject: Re: [TenTec] Noise Reduction Setting
From: "Gary Hoffman" <ghoffman@spacetech.com>
Reply-to: Discussion of Ten-Tec Equipment <tentec@contesting.com>
Date: Thu, 7 Dec 2006 22:38:21 -0500
List-post: <mailto:tentec@contesting.com>
That's all correct.  Perhaps my choice of words was unfortunate.  I did not
say it produced any more GAIN.  Rather I said that the DSP action resulted
in more gains (in the war against noise....that is....it made progress,
reduced the noise further).  But in a quick read it may have seemed I was
claiming that it somehow produced GAIN...i.e., amplification.  It does not,
and I did not.  I agree with the statements you made below.

73 de Gary, AA2IZ


----- Original Message ----- 
From: "n4dsp" <n4dsp@triad.rr.com>
To: "Discussion of Ten-Tec Equipment" <tentec@contesting.com>
Sent: Thursday, December 07, 2006 6:17 AM
Subject: Re: [TenTec] Noise Reduction Setting


> Ten-Tecs position is the NR will NOT increase gain but it
> will increase the Signal to Noise ratio. The NR in my
> Orion II works very well in this regard and I use it a fair
> amount of the time. I did notice a substantial improvement
> from version 2.034 to 2.037j. When using 2.034 and
> setting the NR to 4 caused quite a bit of distortion and
> on the 9 position it was unusable. This was greatly improved
> with 2.037j and for "general" conditions I leave it set to 4
> but I will set it to the 9 position in extreme condtions and it
> will have some distortion which is understandable. I am a
> happy camper with the dsp in the Orion II after using a rig
> from another manufacturer which had dsp. The dsp in that rig was non-
> existent except when set for elimination of ALL heterodynes
> which cannot be used for CW only SSB.
>
> 73
> john-n4dsp
>
>
> ----- Original Message ----- 
> From: "Gary Hoffman" <ghoffman@spacetech.com>
> > But, look beyond that.  Once the bandwidth has reached its optimum (that
> > is,
> > as narrow as seems appropriate to the circumstances) it is NOT true that
a
> > properly functioning noise reducer can produce no more gains.  This is
> > plain
> > wrong.
>
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
>
>


_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec

<Prev in Thread] Current Thread [Next in Thread>