Tony:
A lot of things could be responsible for that problem. If the firmware got
corrupted, reloading would probably fix the problem, but even if not, 2.037j
is an excellent upgrade to do. If that doesn't fix the problem, I would
call Ten Tec and let them walk you through the fix.
Ron N6AHA
----- Original Message -----
From: "EI6DL" <ei6dl@eircom.net>
To: "Discussion of Ten-Tec Equipment" <tentec@contesting.com>
Sent: Wednesday, October 25, 2006 6:04 PM
Subject: [TenTec] Orionll 566AT Main Rx Hang Problem
Hello! All.
Have any of you Ten-Tec Orion ll 566 owners come across this problem ? The
Main Rx on my Orion ll 566AT running V2.032 has hung for no apparent
reason on more than one occasion. Checking the Sub Rx and it receives
fine all the time that this is happening . On the Main Rx there is only
band noise and no audio modulation and no signal modulation showing on the
Sweep display. Switching On and Off the rid has managed cleared this but
not always . Also having left the rig off for a while and switching it on
again has cleared it .
I have been thinking of downloading the latest updated software V2.037j
in the hope that that may remedy the problem ??
73'es
Tony EI6DL.
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|